Elite Dock Bubbler
Quiet, efficient, reliable systems for managing your waterfront.
  • Home
  • About our Product
    • Bubbler System Models
    • Installation
    • Photos
  • Selecting a Bubbler System
  • Dealer Locations
  • Ice Ramps
  • Terms & Policies
  • Contact Us

How to Install the Elite Dock Bubbler

INSTALLATION IS COMPLETE IN 4 SIMPLE STEPS
 
What you will need:  flat head screw driver  / nut driver (1/4")  

STEP 1
-Plug the supply hose onto the pump.  

STEP 2
-Lay the hose out to where it is going to be installed.
-Slip the two stainless steel clamps over the open ends of the main bubbler hose.  Push the bubbler hose onto the       "T" fitting at the end of the supply hose.  *this is the fitting following the check valve from the pump* 
-Tighten both hose clamps until they are snug. 


STEP 3
-Plug the pump into power supply, pump should be on and working.

STEP 4
-Install the weighted bubbler line into the water as close to the structure as possible.  The main bubbler line lays on the bottom and can be moved around easily with a boat hook / pole for adjustments. If needed, Bubbler tubing can be suspended from docks with lines when water depth is greater than 8 feet.

​IMPORTANT REMINDER - ALWAYS KEEP THE CHECK VALVE SUBMERGED!
     (KEEP THIS IN MIND WHEN ORDERING SO THE APPROPRIATE LENGTH OF SUPPLY HOSE IS SUFFICIENT)

Copyright © 2025 Waterfront Innovations LLC.  One year manufacturer warranty on silent air pumps.